The reviews are automatic translation.
Internal deburring, chamfering of the hole or pipe of mild steel
On 2015-08-11 15:39:43
3 uses size. Finish will also feel a little worse than the 3-blade, but it is good. Just a little chatter cheap. Since COSPA is better than the most polished, I think that the initial investment can be recovered in the long run.
On 2015-06-26 17:19:45
I bought I think more economical than change to buy a counter sink.
It has been used in Rajiaru. Aluminum has very clean finish satisfaction.
S50C came out a little way back.
Rotation is starved, such as finished to clean better a little late than Table.
On 2014-09-06 10:01:36
Because although I have missing too soon at the counter sink for the chamfering of the hole in the blank unplugged laser This lodge from around polishing of time and effort does not have a no loss 5Φ because only to replace the blade even longer cut solution without any problem I am happy
Iron, SUS, chamfering of holes in the aluminum
On 2013-10-17 18:31:24
I purchased are attracted to the name, but as the other person is you say, I am satisfied so well you to be finished in a very clean cut. Peace of mind is different. It is also good that the chip replaceable. His is a range of use also has long-lasting far chip. The accessories had been also included wrench for the chip replacement.
Boring after drilling of SUS, iron and aluminum
On 2011-04-11 22:48:54
very good. The carpets we used until now can not be used only for the parts that we often use, even if we go out to polish, the sharpness was not good. I think that this product is very good in terms of cost because it is easy to exchange chips.
Chamfer after drilling of aluminum plate and stainless steel plate
On 2010-09-29 12:13:41
There is only expensive, as expected, the cut is different. This is decided for the part that you want to finish precisely and beautifully. There is nothing to say if it is a little cheaper.