The reviews are automatic translation.
Remodeling of the bicycle (additional transmission)
On 2017-03-03 21:38:55
1-2 There was a need to have a little astringent, and lubrication. Whether the grease was somewhat stiffer? If you do not back the lever of the shift-up by hand could not the next operation. It uses well tone Once dispensed 5-56.
Replacement of outdated parts
On 2017-02-22 20:05:53
Again we had a hard time to set the shift wire Tyco. Was set Tyco from remove the Purakaba Remove the screws of the body. When you disconnect the Purakaba is easy to come off the cover and remove the gray portion of the tip. Are just by looking at the instruction manual that you first look it is impossible set of wire.
On 2017-01-13 13:47:20
It was purchased for the bicycle of renovation for the school bike.
Or disconnected wire, such as was scared likely crack at the time of the plastic cover insertion,
Mounting It was Choi To difficult.
After installation completed will be able to speed comfortably and Kachikkachi', large satisfaction.
On 2017-01-11 18:22:36
The same parts are inexpensively normally saved from entering the hand is so than home improvement and genuine. In securely and feel has been very pleased with the revival.
Granny's bike transmission repair
On 2016-11-16 15:14:06
Irasshai written by other people, but the installation instructions of Shimano is unkind. First as tips,
1 manual of the right to loosen once the cable adjuster bolt in the "method of adjusting the bell crank" for as long as possible the wire. Remove the screw at the bottom of the cover of the transmission. Otherwise, I do not see a hole to fit a drum of wire. 3 when installing the gear shift cable for securing the wire without fixing the transmission to handle. (At this time lever because can easily put a gap to first gear in. Then shifting to the second speed (lower right) and the gap is wire is less likely to come off no longer. Tyco's wire this time is important to make sure that it is properly fitted.) 4 mount the transmission. 5 to adjust the bell crank. Manual is I want you to understand everyone to see.
On 2016-10-08 07:38:04
It was saved by the very good parts.
Shifter exchange outdated
On 2016-09-30 14:14:52
Was the shifter exchange of granny's bike, which was a 10-year period after purchase. Since the shift of the touch is determined and clangor, It is better than the grip type.
The shifter is a little is required knack for mounting the shift wire. The shift lever is in the first speed. Remove the plastic cover. Once the fit is Tyco's wire, pushing down the gear shift lever to the second speed. This wire is securely fixed. This procedure does not appear in the manual. First it would be difficult in leaving the cover.
Also wire There are various sizes. Let's buy from by measuring the length and remove the old one.
On 2016-04-22 16:44:23
I use without problems.
Transmission repair of bicycle
On 2016-04-10 16:16:35
Way of fixing of the wire as it is written in the review does not understand the instruction manual. Beyond expectation it was briefly trims since the work to understand the structure to break down old ones. Try many times when that does not work is to devise the orientation of the wire end. Clearly there is a feel when the subsided.
On 2016-02-03 21:14:51
Into place and the feeling was revived. It seems to have become the new car.