|
|
DIGITAL TORQUE SCREWDRIVER (100-500cN.m)
[x]close
|
DIGITAL TORQUE SCREWDRIVER (100-500cN.m)
(4)
|
Narrow by
* Products that meet your criteria are shown in
table below.
...see all>
|
Customer Reviews
The reviews are automatic translation.
Torque management during assembly of mechanical parts
From Japan
On 2018-03-16 14:55:46
It purchased for the purpose of confirming the torque at the time of assembling small parts and used it, because it is 2 to 3 N in normal use, it does not matter, but if you try to use up to 5 N, you will slip your hand with a driver type. It is a bit tough unless you are doing anti-slip gloves. It is impression that it is tough on driver type coming so far.
Other usability etc. are no problem at all. A model down to 2.5N is perfect.
This review is about item#16426113.
Assembly maintenance of equipment
From Japan
On 2018-02-09 16:58:16
Although it was kept in a case not dedicated to the attached, it became impossible to use it in two months after the start of use because it could not push "P" button.
This review is about item#16426113.
Management of screw tightening work
From Japan
On 2017-10-09 12:32:14
Even if you purchase three units, you can not cover the range of screws handled by us because the set torque range of one unit is very narrow.
This review is about item#16426104.
Experiment
From Japan
On 2016-06-17 16:27:58
I bought it for experiments It was easy to grasp the grip and it was good
This review is about item#16426095.
