It can be installed comfortably by warming it to boiling water for about 5 minutes. It will last long because it has sufficient strength as it cools. Because it was a metal exposed kick arm, there seems to be no hole in the shoe sole.
The outer shape of the rubber was just good feeling, but I feel a little hard. It would have been better if there was a slightly longer thing, but I think that you can refer if the size is listed so how about considering it? I was satisfied with the quality as expected.
Since most kick rubber is not attached to domestic moped scooter, I purchased it. Even if you think that the inner diameter of rubber is thin, you can wear it easily by warming it with heat gun for about 1 minute to 2 minutes, so rubber becomes soft, I think that it can be installed easily. The length was cut off with a cutter according to the kick pedal. When I was kicking, I did not cut into the sole of the shoe so it got easier for the kick.
I try to install the wax used for exchanging the tire, but abandon it because the rubber quality of the product is hard, but if it is immersed for 5 minutes in the boiling water and wears it in the hot state in the kickpetal it will enter easily. When the temperature goes up, the flexibility improves drastically and it is possible to wear on most models. However, recently there are few bikes with kick petals. . .
How to Buy (Negara pengiriman : Malaysia, Singapura, Thailand, and more)
Semua produk tawaran MonotaRO Singapura tertakluk pada undang-undang, peraturan, dan standard pensijilan tempatan Jepun. Sila pastikan ia mematuhi atau tidak mematuhi keperluan negara anda dan/atau organisasi antarabangsa, termasuk tetapi tidak terhad pada, Pensijilan UL, sistem Sijil Wajib Halal, dan Halal.
MonotaRO Co.,Ltd. Hyogo Public Safety Commission No.631330800020