Retention of chip components
On 2016-06-25 20:45:05
Previously, because I like to buy the engineer company of the PT-25,
Tip shape is the same (which should), we here of reverse action tweezers were also purchased, but there was a lot difference in the quality.
More specifically, has become a distorted state ○ of the tip is asymmetrical,
Mating surfaces of the tweezer tip also not parallel,
In plight of course tip it is also shifted, such as,
Is in the company of tweezers, was terribly rough finish.
(Formerly PT-25, which was purchased, the shape as described in the catalog,
It has become a ○ clean R = 0.75, tip was also snug in parallel)
Then, although the package itself I was normal ENGINEER product of things,
Some stuck usually if the company's tweezers
Long round of model number seal (ENGINEER PT-XX, SMD TWEEZERS such as the listed black / silver seal) is not affixed to the PT-26, which was purchased,
ENGINEER PT-26SUS-304 STAINLESS STEEL
Also worried that printing is was only a.
Because we wanted to use in a hurry, but I have to use it again sharpening yourself without return,
Because in the ENGINEER's products were too sloppy finish of the product, is up to you post only review.