Customer Reviews of Spiral tap (for general metric threads) (EX-SFT)
The reviews are automatic translation.
Showing 1 - 9 of 9 Reviews which have 3 star
[ See all 34 customer reviews ]
I will use it to fix the screw
On 2017-05-07 18:01:19
I am going to use it and the condition of the thread is running smoothly I will continue to use it more and more.
On 2017-03-24 18:35:18
There is no problem. In addition, I will purchase it if necessary.
On 2016-07-26 17:25:14
It is very good to use. It is GOOD.
On 2016-05-31 14:43:18
Especially not possible nor impossible
When tapping is necessary when machining hobby machine parts, it is used to tap it occasionally
On 2016-05-03 19:22:01
Previously I bought a hand tap (not a spiral tap), but in the case of a deep tap, the resistance was large and the burning was bad, I could not be satisfied, so the maker was also different, but this time I made it as a spiral tap Although I saw it, I am using it as if it is normal.
On 2013-08-17 10:07:28
It was good because I could purchase a tap of diameter and pitch (M30P1.5) which I would not use easily. I also purchased a straight collet (Φ 23) here to use the tap. I set it in NC milling machine and used it for S50C, but it was able to tap process normally.
Drill hole and thread cutting
On 2012-07-09 14:27:28
On 2012-04-02 19:55:44
it is normal.
I cut M3 tap into 5 mm thick aluminum and fastened a 1 mm iron plate.
On 2010-11-13 11:26:51
It is the first time to use spiral taps, but it is good to discharge the chips above.
Customers Who Viewed This Item Also Bought