Customer Reviews of The pack twist drill for stainless steel
The reviews are automatic translation.
Showing 1 - 8 of 8 Reviews
Cut off 5M tap
On 2017-02-06 22:23:41
Working speed is fast. I will repeat again. I am satisfied.
Drilling of stainless steel
On 2017-01-05 16:50:14
I use it in the pilot hole of the reamer, but the rice cake is also good, the straightness is also good Good flowing is difficult
Mainly drilling of iron and copper alloys
On 2016-11-29 14:50:57
It is relatively inexpensive and polite when used carefully and it is sufficient for general use.
For pilot hole of M5 tap
On 2015-10-14 16:53:16
Because there are many screw processing to aluminum material, I tried using this inexpensive product. Due to changing the drill chuck to high precision, accurate drilling is done without drill blur at all.
Drilling of screw hole
On 2015-02-25 10:58:51
Normally it is not possible and it is normal.
Drill a hole in SUS plate
On 2013-11-18 21:32:46
I tried drilling on a 2 mm SUS plate with a drill tooth on a hand held electric drill + titanium coat with amateur DIY, but it took 1 hour, and gradually the position of the hole gradually deviated by 4 mm. Half a half, I got this product dedicated to stainless steel, when using it, it took less than 5 minutes, and it was possible to drill up quickly. It seems that the fox has pinched it. You can do a good job with good tools. Please try.
Tap pilot hole
On 2013-05-16 16:12:56
Is no problem
It is SUS plate drilling work
On 2012-11-21 13:17:35
Continued, quality is of course, if you can do a little more price, I think that you will not mind other companies' prices on the net.
Customers Who Viewed This Item Also Bought