The reviews are automatic translation.
Iron rust remover general
On 2017-06-08 13:23:46
I use this with a wire cup brush, but the flat place is faster and durable this way. I am using it for rust removal etc. of the chamber of two wheels, but even with terrible rust, the work will proceed smoothly.
Besides aluminum type
On 2017-03-04 09:26:39
Since aluminum clogs are fast in aluminum type, iron and stainless steel are mainly used. The feeling of use is surprisingly good, because it is different from all overseas manufacturers, I realize that there is a difference in durability and finish, I guess it is just as brisk as a cospar, but in order to reduce expenses even a little, Although it will be scraped away from expendable supplies, we are proud to say that it is contradictory to expanding domestic demand on the contrary
Grinding and polishing of steel materials
On 2017-01-12 10:04:17
The "Zen mona tiger" brand Z 40 felt as if it became a black label and the performance went down a little. Since the picture at the time of purchase was a blue label of "Monotaro" brand, I tried to purchase a small amount for a moment but it was a black label that came. The black label is also not bad. Z 60, Z 80 did not feel charm with lack of grinding power in ironware like us.
On 2016-07-29 18:29:48
It is good. I am satisfied. I can use it until 3/4. The rest can be used for other purposes. This is good.
On 2016-06-07 19:40:32
It is a GOOD material. I worked hard at this price! Although there is no problem with one grade below, I feel that this person has better momentum (bite). I will try again so please do your best and keep making it.
Metal surface finish
On 2016-05-17 18:25:53
It was used for surface finish. Especially satisfactory with moderate cutting without problem.
Stainless steel tool for maritime
On 2016-04-29 15:23:27
It is used for sharpening stainless steel tools (keys, anchors, pipes around ships, etc.). I hope there is not too much shaving.
Rust removal of iron plate
On 2016-03-11 19:13:44
I hope that it is a bit cheaper.
Metal cutting and surface grinding
On 2016-01-14 14:52:29
The price has increased considerably from the old product which became the abolished version, but the durability may have further increased. (Price is cheaper than other companies' equivalent)
On 2015-02-04 13:35:20
It is the easiest to use ever used.
On 2015-01-13 20:52:01
It was able to polish very quickly and the work efficiency rose.
Deburring of metal product cuts.
On 2014-06-17 11:59:17
Cospa is expensive. As a feeling of use, although it feels lower than other products, the price is low, so even if the exchange frequency increases, the amount to be used is large, so it is cheap in total
On 2011-12-05 20:40:21
Can be used without problems
Painting · Masked peeling, bead grinding, rough cutting.
On 2011-06-17 13:17:24
It seems that the dispersion of abrasive grains is large. Also, due to grinding heat, I do not know because of the structure, but often there are times when it gets out of service. I think that cost performance is high, so it would be better to divide it if it is used properly according to the work content.