Buy more than* S$200* and get FREE SHIPPING

Adhesive

Sort by:
Showing 1 - 30 of 88 Results
Show: 30 60 90
VIEW: Grid View List View
Bond Adhesive, Wood, CH18
Konishi
102.42 SGD
ADD TO CART
Revision of the Architecture Standard Act (JIS Supported): F (JIS A5538 / JIS K6804), Environmental Information: Health housing support. JAIA 4VOC compliance with standards., Ingredients: Vinyl acetate resin emulsion form
Category Adhesive
Bond Adhesive, Forming Polystyrene
Konishi
4.75(4)
1.79 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Content of Hazardous Material: 20mL, Danger Level: II, TRUSCO Part Number: 447-4775
Category Adhesive
30 ml plastic adhesive
ESCO
13.29 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., ESCO Part Number: EA935A-12
Category Adhesive > Plastic, Vinyl, Styrofoam Acrylic
CEMEDINE1500, Adhesive
Cemedine
5.00(2)
309.90 - 1,129.90 SGD
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Glass Tansition Point (℃): 54, Hardness (Shore D): 82, Water Absorption Rate (%): 0.8, Hardening Time (hour): 6, Linear Expansion Coefficient: 7.1x10-5, T-Type Peeling Strength (N/mm): 0.4, Tensile Shear Strength (N/mm2): 15.7, Available Time (minutes): 60, Volume Resistivity (ohm cm): 7.1x1015
Category Adhesive
Repair Bond
Konishi
5.00(1)
2.83 SGD
ADD TO CART
The nature of the hazardous materials: Non-water-soluble, Content of Hazardous Material: 7.5g, Product Name of Hazardous Material: Fourth petroleum, Types of Hozardous Materials: Fourth class, Danger Level: III, Main Ingredient: Epoxy resin system
Category Adhesive
Metal Rock Y618LD
Cemedine
4.50(2)
67.43 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Modulus of Elasticity (N/mm2): 451, Impact Strength (J/mm2): 18.0, Break Strength (N/mm2): 10.5, Glass Tansition Point (℃): 61, Hardness (Shore D): 47, Content of Hazardous Material: 600g, T-Type Peeling Strength (N/mm): 6.02, Tensile Shear Strength (N/mm2): 13.7, Fracture Elongation (%): 40, TRUSCO Part Number: 364-6238
Category Adhesive > 2 Fluid Compound
2-component epoxy adhesive Hysol 0151
Henkel
87.94 SGD
ADD TO CART
2015 Trusco Published Pages: 3 0988, 2014 TRUSCO Published Page: 1-2600, Mixing Ratio: 2.7: 1, Hardening Time (hour): 3 - 4 hours (25 degC ), Mass (kg/set): 135, 135, Available Time (minutes): 60, 60, Main Ingredient: Epoxy resin, Capacity (g): 93, 93, Hardness: 85 (Shore D), Color: Clear, Type: Two-liquid mixed type, TRUSCO Part Number: 364-6408, 364-6408
Category Adhesive > 2 Fluid Compound
LOCTITE visible light curing adhesive
Henkel
4.00(1)
55.59 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Viscosity Range (mPa-s): 200-400, Capacity (g): 25, Hardness: 75(HdD), Weight (g): 46, TRUSCO Part Number: 366-9815
Category Adhesive > Ultraviolet Curing
Epoxy adhesive 2000 (Standard type)
Araldite
4.00(2)
149.90 SGD
ADD TO CART
2015 Trusco Published Pages: 3 0993, The nature of the hazardous materials: Non-water-soluble, 2014 TRUSCO Published Page: 1-2602, Product Name of Hazardous Material: Third petroleum, Types of Hozardous Materials: Fourth class, Danger Level: III, III, Curing Time (minutes): 420, 420, Available Time (minutes): 100, 100, Main Ingredient: Epoxy resin, Operating Temperature Range (deg C): -40-100, -40-100, Type: Medium-viscosity type, high toughness type, Color: Amber, Type: 2-liquid mixing adhesive, TRUSCO Part Number: 384-8302, 384-8302
Category Adhesive > 2 Fluid Compound
Filling adhesive set for metal repair
ThreeBond
119.90 SGD
ADD TO CART
2015 Trusco Published Pages: 3 0991, 2014 TRUSCO Published Page: 1-2600, Semi-cured Dry Time (hours): 5, 5, Product Name of Hazardous Material: This drug / non-hazardous materials curing agent / third petroleum, Types of Hozardous Materials: This drug / non-hazardous materials curing agent / fourth class, Hardening Time (hour): (25 degC ) 24, Mass (kg/set): 2.4, 2.4, Available Time (minutes): 60, 60, Main Ingredient: Epoxy resin, Capacity (g): 1500, 1500, Weight (kg): 2.4, 2.4, TRUSCO Part Number: 243-8852, 243-8852
Category Adhesive > 2 Fluid Compound
Weld EPX Adhesive
ThreeM 3M
5.00(1)
41.21 - 48.32 SGD
Weight (g): 50
Category Adhesive
LOCTITE curing accelerator 7109
Henkel
53.72 SGD
ADD TO CART
Viscosity (mPa / s): 3, Drying Time (sec): 5, Available Hours: (After application) 1 min, Weight (g): 104, 104, Color: Transparency, TRUSCO Part Number: 332-5911
Category Adhesive > Instant Adhesive > Primer
LOCTITE curing accelerator 7386
Henkel
38.75 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Viscosity (mPa / s): 1-2, Weight (g): 180, TRUSCO Part Number: 335-3079
Category Adhesive > Instant Adhesive > Primer
Junior kit
VELO METAL
4.50(2)
429.90 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Weight (g): 250, TRUSCO Part Number: 275-1305
Category Adhesive > 2 Fluid Compound
Cross for Toretore
YAYOI CHEMICAL INDUSTRY
149.90 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order.
Category Adhesive > Paint Remover
Adhesives
YAYOI CHEMICAL INDUSTRY
5.00(1)
13.29 SGD
ADD TO CART
Purpose: Step repair of control panel and plywood., Formaldehyde Class: Unregulated, Construction area: 1m2 / 1kg (1mm thick), Type: Floor part min repair agent
Category Adhesive
Bond E200, Adhesive
Konishi
5.00(1)
199.90 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Content of Hazardous Material: 5kg, Danger Level: III, TRUSCO Part Number: 374-8316
Category Adhesive
Bond E206
Konishi
4.00(1)
159.90 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order.
Category Adhesive > 2 Fluid Compound
UV light (Unisola)
Unitec
139.90 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., AS ONE Part Number: 1-9842-11, Ultraviolet wavelength (nm): 385, Power Consumption: 9W, Power: AC100V,50/60Hz, Dimension (mm): 80x230x125
Category Adhesive > Ultraviolet Curing
Cemedine # 321
Cemedine
139.90 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Content of Hazardous Material: 180mL
Category Adhesive > Plastic, Vinyl, Styrofoam Acrylic
Primer
Cemedine
4.00(1)
30.34 SGD
ADD TO CART
The nature of the hazardous materials: Non-water-soluble, Content of Hazardous Material: 500g, Product Name of Hazardous Material: First petroleum, Types of Hozardous Materials: Fourth class, Danger Level: II, Type: Ethyl acetate / butyl acetate xylene, Capacity: 500g
Category Adhesive
CEMEDINE Hello 750
Cemedine
10.85 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Capacity: 750g
Category Adhesive > Woodworking
Instant adhesive TB1783
ThreeBond
5.00(1)
38.44 SGD
ADD TO CART
The nature of the hazardous materials: Non-water-soluble, Viscosity (cP): 1000, 1000, Product Name of Hazardous Material: Third petroleum, Types of Hozardous Materials: Fourth class, TRUSCO Part Number: 813-0560, Ingredients: Cyanoacrylate series
Category Adhesive > Instant Adhesive > Multipurpose
Deb tube repair agent
Devcon
22.32 - 23.78 SGD
Caution: This product is manufactured in Japanese standards. Please check the specification before you order.
Category Adhesive > 2 Fluid Compound
Devcon ET High transparent casting resin
Devcon
4.60(5)
41.93 - 169.90 SGD
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Heat-Resistant Temperature (deg C): 90
Category Adhesive > 2 Fluid Compound
PANDO 2-liquid mixture type industrial repair adhesives
ThreeBond
1.00(1)
84.77 SGD
ADD TO CART
2015 Trusco Published Pages: 3 1052, Hardening Time (hour): About 24, Available Time (minutes): 50, 50, Main Ingredient: Epoxy resin, Capacity (kg): 1.0, 1.0, Color: (The agent) white, (curing agent) blue green, Weight (kg): 1.1, 1.1, TRUSCO Part Number: 470-3456, 470-3456
Category Adhesive > 2 Fluid Compound
Gonna 20ml stick adhesive for cushion
Car-Boy
9.37 SGD
ADD TO CART
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., TRUSCO Part Number: 440-3207
Category Adhesive > Plastic, Vinyl, Styrofoam Acrylic
Bond woodworking for quick-dry mini
Konishi
5.00(1)
2.21 SGD
ADD TO CART
Raw Materials: Vinyl acetate resin emulsion type, Set Contents: 20gx2
Category Adhesive > Woodworking
Cemedine woodworking for quick-dry
Cemedine
4.25(4)
12.59 SGD
ADD TO CART
Revision of the Architecture Standard Act ((JAIASupported): F , Capacity: 1kg, 1kg, Color: Transparency, Ingredients: Vinyl acetate resin emulsion system
Category Adhesive > Woodworking
Cemedine Nozzle/Cap
Cemedine
1.00(1)
2.87 SGD
ADD TO CART
Purpose: For Wood seal and wall seal, Capacity: Single nozzle, three cap
Category Adhesive

1 2 3 Next