The reviews are automatic translation.
For lathe operation
On 2018-11-22 17:34:52
Although I have not used it yet, I am satisfied with the price, apparent quality etc.
On 2018-01-19 16:57:13
It is cheaper than an entrance dealer, I want you to handle HT 110 4 - 3 fast. I expect it.
Brass product processing
On 2017-12-21 09:51:25
I hope to adopt the right handed cutting tool by
On 2017-04-18 23:30:11
In reverse direction 44-3 of 43-3 it seems that manufacturers will not accept orders only in 10 units, Monotaro says 10 ten 20 pcs 30 pcs and make manufacturers to sell in 1 unit There is enough order I think
End face machining
On 2017-01-05 21:11:45
On the contrary, I want the byte [44 type] where the chip is on
On 2016-11-28 07:26:11
I would like to get the chips a little thicker. To give strength
On 2016-01-12 16:25:24
It is possible to shave better than the carbide chip byte included in the desktop lathe. I sharpen myself to the blade width 2 mm.
45C SCM 435 (material A) Cut-off (mini lathe)
On 2015-11-03 21:31:48
ST 110 is selected. Because the lathes rigidity is low and the roots are stingy, they are falling in width until 2 mm. It is just right for sharpening practice as the price is appropriate.
Cutting and groove processing in 3 scale lathe
On 2015-09-22 23:35:13
Since Sanwa has no one of the same size, I purchased it here. Even with a bigger size, we can not feel the difference between the quality of both manufacturers, so after that price problems. There are no problems in use, you can buy with confidence.
On 2013-05-29 20:24:38
I bought it where I had a contract until now, it was about double the price. I really appreciate it because I often use it. I want to purchase it again. I guess!