The reviews are automatic translation.
Drilling of aluminum plate
On 2018-11-17 17:14:25
Even without positioning with a punch, it was possible to drill beautifully without deviating from the aimed position.
Drilling of aluminum panels
On 2018-09-30 00:38:39
Post-processing is easy because there are few back burrs (not at all). Just about Φ 7.5 mm has the same degree of misalignment as the ordinary drill with a tip of about 5 mm. I think that Mitsubishi's plate pull drill EPSS has less misalignment.
On the other hand, in the case of placing a through hole after VUCDSCB for Mitsubishi's violet precision drill spot facing, it is best for the tip to be an ordinary drill shape because the core is not determined in EPSS.
Drill holes in the thin plate
On 2018-09-16 01:20:06
The position is difficult to shift. Drilling speed is fast. Bali is reduced and it becomes a beautiful circle. It was a good product.
On 2018-07-07 00:17:21
I think that it is good for drilling which I do not want absolutely misalignment.
However, the sharpness of the small tip drill part is not so good and takes time.
Drilling of a frame of a large-sized vehicle and body processing
On 2018-04-11 19:06:11
I tried to drill a 20 mm iron plate with 12 mm drill. I used a grinding oil spray, but I got a hole beautifully comfortably without having heat. Is it possible with high tension?
For plastic processing
On 2018-01-07 16:56:09
With the drill blade up to now I was in trouble because the cutting edge was quite rampant, but this product can not drill a blade and can drill a very beautiful perfect circular hole.
t0.5 Drilling of tinplate
On 2017-09-08 13:38:40
Used in drilling machine.
Although the position is easy to target, Bali will appear as it is and no real circle will come out.
Eventually, deburring also became necessary through reamers.
Drilling to 5 mm thick resin plate
On 2017-02-02 15:05:36
In ordinary drills for iron and steel, when the bit penetrates, it gets caught on the board and the hole can not be opened beautifully, but you can drill precisely without using this bit or casually though the hole can not be opened cleanly. However, since it will be caught if you send it earlier so as to open a hole early, I think that it is a point to send slowly.
Drilling of plastics
On 2016-03-01 22:17:29
It was good because drilling at one time is possible
To use for drilling on thin plate
On 2015-11-08 18:54:06
The hole can be machined to the thin plate as accurately as possible.