The reviews are automatic translation.
Measurement of spindle blur of wood working lathe
On 2018-11-13 21:04:22
Although it is low price, I think that the slip of the tip part is not so good.
On 2018-10-18 14:53:33
There are a lot of dial gauges, but Monotaro's dial gauge is cheaper and easier to use than anywhere.
To measure the blur of the brake rotor
On 2018-10-11 19:25:23
It was able to be used without problems with a set of the magnet base of a monotaro.
To adjust the seating surface of the disk rotor
On 2018-10-01 17:42:39
It can be used as a conventional analog meter without any problem as precision adjustment as well. The price is also cheap and saved.
Surface appearance of instruments
On 2018-09-27 10:25:57
The needle of the short hand is slightly shifted from the time of opening and it feels bad. It is mainly measurement of the long hand part so I do not want trouble in work but I want you to inspect it when shipping.
Measurement of play of the front hub of Benz
On 2018-09-19 15:28:08
It was a measurement of 0.01 ~ 0.02 mm, so it seems that gauges up to 0.005 were better.
On 2018-09-18 16:06:11
Dial gauge attachment It is eccentric when turning machining,
Centering when fixed
Scale of wire tension gauge
On 2018-08-21 17:03:51
It is low cost compared with Mitutoyo etc but it was usable normally.
Measurement of runout of motorcycle wheel and brake disc
On 2018-07-11 06:52:32
If it is a brake disc with fine asperity it will catch on the tip. It would have been nice if the tip roll well, but luxury can not be said when considering the price.
I use it in polishing work at the factory.
On 2018-06-06 15:04:58
Although I am using it several times, it is a very good product. There seems to be no improvement.