Customer Reviews of Electromagnetic Switch Contact Kit SZ-MC Type
The reviews are automatic translation.
Showing 1 - 4 of 4 Reviews
As expendable parts of SC-4-1 made by the company
On 2018-03-07 11:15:29
Opportunities to surge against machinery manufacturers are weak, and the opportunities to use are increased due to the influence of contact sulphurization due to operational environment. If we can detect the deterioration condition early, we will exchange it before the housing gets burned. It is more economical than exchanging each body.
The mold heater is turned on and off with a temperature controller, and there is a magnet SC - O in the middle of the wiring
On 2018-03-04 18:06:21
Fault of magnetic contactor is almost 99%? It is damage only at one main contact part. Until now, only terminals that can be used from a broken electromagnetic contactor can be gathered together and made into one, or if it can not be done, a new article was ordered to an electrical construction shop (since it is a high price when asking for a machine maker) . I did not know that I can buy only the main terminal so I had been considerably losing so far. Cost reduction can be done from now on!
Contacts worn out and replaced
On 2017-12-22 17:06:29
If the replacement terminal is changed, it can be used normally, resulting in cost reduction.
Machine repair parts
On 2015-08-07 14:38:42
I am using the electromagnetic contactor in various machines for replacement repair. However ... compared with a new one, it is rather expensive ...
Customers Who Viewed This Item Also Bought